Good evening worshippers of the Plague Father and thank you for joining us again. Today I would like to offer up a simple alternative to the small flying bases from Games Workshop. I have made this as I have broken more than my fair share of these on Destroyers, Hammer Heads and Crisis Suits.
I was going to attach a magnet to the plastic rod but then I saw a set of Geomag toys on ebay for a couple of pounds which came with 36 rods and a large selection of ball bearings. The rod itself is a hard plastic with a rare earth magnet stuck in each end so you could easily make something similar yourself with a bit of dowel and a sunk magnet though with the cost of magnets alone I liked them.
I started by priming the rod black, as the ones I have are a mix of red, blue and yellow. I stuck this onto the plastic base with super glue as I wasn't sure how poly cement would behave with this type of plastic.
To attach it to the destroyer in this case I used a flat headed screw, if you go this route remember to check they are magnetic before attaching. You could easily swap this out for another magnet or a piece of steel rod which would work nicely and could be made to sit flush with the model if you attached it inside.
I have used this stand on my Destroyer Lord in a couple of games now and is has served me wonderfully compared to the standard ones I used to break on a regular basis.
Until next time keep spreading his word to every corner of the universe.