Bloodcrusher WIP

So I've been trying to get more contrast on the model and I wanted the model to be like 'eye candy' and draw attention towards it. I went to an art store to pick up some things and browsed the paint aisle and started looking at some of the inks that Liquitex and FW had. I decided to buy some red ink and black ink to give it a shot and use it as a wash and do multiple transitional layers on the model to see if it would 'pop' more. And behold........the outcome......



I do think that the model stands out more now and I have to admit, the inks I bought were amazing. I am made up my mind that from now on, I will be base coating and using primary colors from GW and blending them with the different colored inks from liquitex to make the final product.

For example:

This was the test piece that I painted before touching the bloodcrusher just to see the effects the ink would have. All I did was paint the body with Mechrite Red, then I used Liquidtex Pyrrole Red ink and painted about 5-6 layers with dry time. (The stuff drys faster than GW paint and water mix and is more translucent so you can see the paint below better. i.e.: the red to black) Then I used Carbon Black and mixed a little bit of water, almost a 2:1 ratio of water:ink and continue to paint on about 5-6 layers. That's it! Total paint time was about 15 minutes or so. AMAZING stuff I tell you. Only bad thing is that it dries glossy, but that can be fixed with a matte spray.

Thoughts and comments....