 |
| The Tormentor Titan |
So I did some digging into the dark corners of the internet to find out about where the army stands in Epic. There isn't really anything in the official Epic rules for Dark Eldar, but there is a community who put together rules to expand the game and include Dark Eldar, along with other "lesser races" in the form of the Epic Raiders fandex. So obviously the cover is as far as I needed to look to know I wanted the Dark Eldar Tormentor Titan.
I've played around with some rules ideas to guide what I want to build, but I'm going to keep those to myself until the project is done and I can fit them to the model. I've finished the leg model, and have an idea on how it's attaching to the body assembly, so I picked up some Mold Max 30 silicon rubber to cast the part. I hadn't used the product before, but I liked it being a mix by weight product which made it more exact with the use of a kitchen scale. I built a mold box, and set the leg into clay, along with some bolts for alignment keys, and cast the first half of the mold, planning on doing a 2 part mold. There wasn't any real problems, everything went smoothly. I hit the local Michael's and got some mold release, removed the clay, and hit the part and mold with some mold release. I then poured the second half of the mold.
Problems occurred! The mold release either didn't properly cover, or reacted with the silicon mold compound, there was no release between the mold halves, I had a part encased in a block of silicon rubber. So I went about splitting the block and getting to the part. I managed to extract it and was basically left with a split mold. From reading I knew this wasn't going to be as durable or reusable as a 2 part mold, but I figured I'd give it a try. Now usually I'm using much smaller molds, and often they are placed snuggly into boxes of some sort, but this mold was a bit larger, so I tried using some boards held tight with some elastics and straps. Once I started pouring the resin, it was obvious these weren't tight enough, because resin seeped out the sides and bottom. I tightened things as much as I could and finished pouring the mold.
It didn't turn out terribly, I got a lot of flashing and bubbled edges because of the seepage, but it could be salvageable. I noticed that the mold itself has a couple of major bubbles on the one side, likely the second half, but they should be fixable, the biggest issue with this cast is that the top ball joint and edge of the leg only had the resin harden on the mold while some of the resin seeped out, making them hollow.
 |
| Bubbles in the mold |
 |
| Rough edges because of seepage |