Hi One and All,
Another quick Reaver post to update on progress,
I've started with the legs, and aimed to get the Reaver in a slight 'striding with purpose' pose, with one foot stood on the Rhino, the other aimed to be slightly up, as if walking forward. The hope is by spreading the weight of the body across the legs that should prevent any falls.
Each leg/knee/hip joint was pinned and then fixed using JB Plastic Weld, a two part epoxy resin, mega strong! Rubber bands were used to secure the joints in place as it set.
The plan will be to drill additional pins through the pelvis section into the hip ball to add strength to secure the model, - I intend to have the hip/body section magnetised, thus there will be a lot of force on this joint when the two are 'pulled' apart.
Thanks for looking!
Another quick Reaver post to update on progress,
I've started with the legs, and aimed to get the Reaver in a slight 'striding with purpose' pose, with one foot stood on the Rhino, the other aimed to be slightly up, as if walking forward. The hope is by spreading the weight of the body across the legs that should prevent any falls.
Thanks for looking!