Hi All

Bluddtoof here with a much delayed update on my progress on the Eldar Corsair Hornet.
My previous post on this showed the build, including the scenic base, find it here. Unfortunately I had something of a disaster during the next step which I will now explain....

So I started the process of painting the base, this needed to be done in a few steps as the plan was to use water effects to simulate a water filled trench. I started by painting the concrete trench wall,




I had painted the slimy water beneath the walkway during the build so at this point I painted the rusted metal walkway. I took the second photo with flash so the colour of the water shows up better.
Next I moved onto the pipes and painted the base in the green slimy colours which would show through the water effects...





I also added some weathering and moss effects across the concrete, as well as a freehand peeling poster by the valves.
Once I was happy with all that it was time to tackle the water effects; I built a mould around the base using a piece of thin plasticard wrapped tightly around the base, this was lined with a sheet of greased cling film to stop the water effects resin sticking to the mould...



It all went incredibly well to this point, first time I'd tried this and well happy so far, I then proceeded to pour the thin layer, about 1 1/2 mm deep into the mould..... no seepage! Huzzah!
I left the model in nice warmish room to set, a day later no change, nor the next day or the 2 after. At this point I was a little concerned as the resin was showing a marked dip in the centre, I checked for leaks but all was good there. Next day some of the resin was starting to clear but only in the middle of the 2 sections, so 4 days in and it was barely setting, I decided to check the bottle to see if there was a best before date; no such thing, however I did spot the GW copyright text which was dated 2000-2005, implying that the bottle was as much as 10 years old! I had a little think and realised that yes this was the very bottle I used nearly 10 years ago when I built a series of water filled craters for a scenery project! Now I don't know for sure if age was the primary cause of the failure to set but I suspect it played a major role. 6 days later the resin had still not set but had in fact taken on the consistency of cottage cheese!
At this point I decided to carry out a little exploratory surgery; removing the mould which pulled a mass of gloopy, cloudy resin with it. I then spent a pleasant couple of hours scraping and cleaning to remove the residue, in the process I had to remove the mesh walkway completely and some of the pipework too.
This was the weekend before Christmas so finishing in time for the judging was unlikely, I was now nearly 2 weeks behind schedule. So I had a few days off and then set to work redesigning the base and building the new bits. I've gone for a more pipe filled dry trench now, here's some pics of the newly rebuilt base, some of the paintwork was unaffected as you can see...






I'm now in the process of repainting this and I actually quite like the new look, I will be buying some new water effects resin for use on other models in this army, I have a plan for a large base depicting guardsmen crawling through sewer pipes to evade a prowling grav tank

So to close, if you're planning on doing something similar, check that your resin is still in good condition before committing it to your models!

Stay tuned for more updates as this progresses.

Bluddtoof