In the Dragons Den (7)

by | Jul 6, 2018

Hi all,Since I wasn't sure of the scene layout, I did some re-arranging.First I looked at re-positioning on a wider board. But that didn't improve either, so I rather decided to use the original board, but angle the scene.With this set-up I have enough space...

In the Dragons Den (6)

by | Jul 4, 2018

Hi all,despite a digestive virus I have been busy for the last few days :)The legs of the Meacha Dragon were a bit troublesome and so I did several sketches before I was pleased with the design. This is the start of a rear leg and the corresponding front...

In the Dragons Den (5)

by | Jun 21, 2018

Hi all,so with the idea of the night before in mind, I created some ribs or vertebrae in PPT and printed them.I then glued them onto the plastic card with Fix-O-Gum - a temporary glue - and cut themAfter cutting them all out I glued them onto the prepared spinal...

In the Dragons Den (4)

by | Jun 20, 2018

Hi all,so I decided to take on the Steampunk theme and our little heroine - Tomb Raider much? - received the appropriate clothes.And accessories  With boots and belt and doo-dads 😀  Too bad, most of this won't be visible ... Next she received a...

In the Dragons Den (3)

by | Jun 15, 2018

Hi all,last night I decided to head down the Steampunk route. So she got some high boots - note the actual "shoe" is still WIP  Belts and accessories  With cogs and stuff. Too bad that the front will hardly be visible in the end... I'm still...